Six technical requirements of machining

Six technical requirements of machining

Six technical requirements of machining

     The following is a Cheng Lung Machinery Company now bring you information about six technical requirements of machining content introduction, I hope you can put forward your opinion after reading.
1, should be uniform contact with the flat key keyway both sides of the shaft, with its surface can not be a gap;
2, the assembly of the hydraulic system allows the use of packing or sealant, it should be prevented from entering the system;
3, the assembly process is not allowed parts knock, touch, scratches and rust;
4, machining parts in the assembly must be cleaned and clean, without burr, flash, scale, rust, chips, oil, colorants and dust;
5, the bearing outer ring and the open bearing and bearing cap are not allowed to have a semi-circular hole jamming;

6, the assembly of the hydraulic system allows the use of packing or sealant, it should be prevented from entering the system.

NEWS FROM CNC MACHINING PARTS COMPANY EASTAR