Scratches after cnc machining center hole machining how to do?
CNC machining center after making hole machining scratches how to deal with such cases, first
1, look at changing the process can see, there may be a parameter set unreasonable,
2, on the other hand an effective way to prevent scratches is to use instead of boring drilling process selection wrong.
3, the first to see the diagram to know, if the thickness of the workpiece machining CNC machining centers is not very thick, you can use about 4 hinge Daojiao, you may also slow the coolant water and water is not enough, not crumbs row out
5, angle drill grinding good point, and you penetration rate is too high, it is about 100 alloy cutter Vc, Vc drill machining iron about 40 on it.
Question two, when FANUC 0i CNC lathes boot alarm, reflecting the main motor overheating, and power distribution cabinet behind a contactor jump, in which case what then?
First contacts have to check the hell is dry and does not jump is not a contact.
Secondly also check whether the line corresponds to the phenomenon. Again to check the corresponding drive motor has no problem
The above three points should be sufficient to resolve these problems CNC machining centers.
NEWS FROM CNC MACHINING PARTS COMPANY EASTAR
