Parts processing, CNC lathe processing sharpening precautions
In the use of
CNC lathe processing, parts processing is the need to use a variety of different tools for cutting and cutting tools. The tool in the use of a period of time will become blunt, if the direct removal of these tools is a pity, but also greatly increase the processing of parts and CNC lathe processing costs. So the processing of the secondary production of the tool is necessary, the following gives you about CNC lathe processing parts processing sharpening Note:
1. grinding tool can not force too much, otherwise it will make the hand slip and hit the wheel surface, resulting in industrial accidents.
2. Grinding the tool before, should first check whether the grinding wheel crack, wheel shaft nut is tightened, and after the trial run to avoid grinding or flying out of the wheel.
3. Grinding wheel bracket and the gap between the grinding wheel shall not be greater than 3mm, into the discovery is too large, should be adjusted properly.
4. sharpening should wear protective glasses, so as not to sand and iron into the eyes.
5. When grinding the small knife head, you must put the small knife head on the pole.
6. Do not place the grinding wheel in the direction of rotation of the wheel to prevent accidents
